No listing for your setup? Show us both sides.
A useful request describes two real mating surfaces. Use the form below to send the checklist. Do not send only a nominal hose label.
1
Identify both connections
Give the equipment brand/model and say whether each side is a rigid OD, socket ID or flexible hose ID.
2
Measure twice
Record diameter at the opening and 20 mm deeper, with units. A caliper is preferred.
3
Add clear photos
Include a side view and an opening view with a ruler or caliper visible.
4
Describe the job
Tell us which side goes into which and whether a friction fit, clamp or quick-change joint is needed.
Custom work is reviewed before any commitment. A request is not an accepted order or a promise that a safe printable solution exists.
Submit the connection details
Submissions are stored in the store dashboard even while transactional email is being configured.